During use, if there is deviation, the following inspections should be conducted to determine the cause and make adjustments. The parts and handling methods for frequent inspection of conveyor belt deviation are:
(1) Check the misalignment between the transverse centerline of the roller and the longitudinal centerline of the belt conveyor. If the misalignment value exceeds 3mm, it should be adjusted using the long installation holes on both sides of the roller group. The specific method is which side of the conveyor belt leans towards, which side of the roller group moves forward towards the direction of the conveyor belt, or the other side moves back.
(2) Check the deviation values of the two planes where the bearing seats are installed on the head and tail frames. If the deviation between the two planes is greater than 1mm, the two planes should be adjusted within the same plane. The adjustment method for the head drum is: if the conveyor belt deviates to the right side of the drum, the bearing seat on the right side of the drum should move forward or the left bearing seat should move back; if the conveyor belt deviates to the left side of the drum, the bearing seat on the left side of the drum should move forward or the right bearing seat should move back. The adjustment method for the tail drum is exactly the opposite to the head drum.
(3) Check the position of the material on the conveyor belt. If the material is not centered on the cross-section of the conveyor belt, it will cause the conveyor belt to deviate.
If the material deviates to the right, the belt will run to the left, and vice versa. When using, the material should be centered as much as possible. To reduce or avoid such conveyor belt deviation, a baffle can be added to change the direction and position of the material.
